[Requesting Help] DupeX/DupeXmon vac (yes, I have searched)

[imortalweapon]

I recently got a friend into hacking, I helped him set up and get his addresses and values etc.

Everything seems to work except for dupeXvac as well as dupeXmon

However, those two vacs work perfectly fine for me, I don't quite understand why they don't work for him, that's why I'm here asking for help.

I have searched multiple forums trying to figure out if the question has been answered before, and it doesn't seem to have, at least not recently.

When injecting the code into the auto assembler, he doesn't seem to get any address that would work with DupeXvac, normally I believe you are supposed to get addresses that start with something like "0b??" but he always gets addresses that start with "0f??".

He has tried using them, adding the address "0f??0400" to the cheat table and changing the EIP address at 5f0d4c to "0f??0000" but the value for the address he adds doesn't go up, it just stays at 0.

We have compared settings for our UCE and they seem to be the same.
He can get all the public hacks (posted in the sticky forum) to work fine, all except DupeVac.


Please help, thanks in advance.

edit: He tried using the dbk32.sys file from this forum and whenever he tried dupe his PC would reboot.

He deleted the .sys file and tried again, both dupes work now, BUT he gets disconnected after a bit of vaccing with dupe.

He uses miss, dupe, and speed attack. I told him to try without speed attack because I know it disconnects the person often if "abused" and he said he still gets disconnected.

He does have the dbk32.dll file, it's the same one I use.

He still gets the 0fxx results from the auto-assemble, some work and some don't for dupe.

Can anyone explain why he gets results from auto assemble that start with like 0fxx instead of 0bxx or maybe why he gets disconnected frequently?

[st3ph3nt4n]

Misunderstading

-=Thread Reopened for posting =-

[Varsis]

make sure you also change the watch value to the same 0f??0000 in your address list
or it'll never go up

[HaganeKotetsu]

make sure you also change the watch value to the same 0f??0000 in your address list
or it'll never go up

What do you mean the watch value.. Because right now the only problem I have with the dupex is that I cant get the value to go from 0-1.. Ive done everything right according to various tuts.. What do you mean by the watch value? Is that the Listoffset addy your putting onto the address list?

[N3Wl3]

The number won't increase if there's someone else on the map. Also, it won't go up unless you have the edited dbk32.dll or dbk32.sys (forgot which one), which he probably has since you probably gave him your UCE.

[imortalweapon]

I did give him my dbk32.dll, he tried using the .sys one from this forum and every time he uses dupexmon his comp restarts.

dbk32.dll seems to work though, at least for allowing him to edit four addresses


edit: He can get some of the "0fxx" addresses to work with dupe now, but he seems to get disconnected after a few minutes, both with and without speed attack on. I think he uses misshack not god mode, if that matters.

edit 2: He deleted his dbk32.sys file and tried again when it worked