trainer/softice

[bluebird]

I'm working on my trainer for joint ops, using tsearch for the most part. I rather be using softice. Is there a way to load your programs (joint ops) into softice without having to make a sym file. or is there a quicker process than what I've been doing.

make a map file in IDA, then run through 2 conversions to get to a symbol file to load into softice. This info with softice in the past was very limited and this what I found to work, but would rather spend my time on my trainer than converting files.

Thanks in advance

[Virtuosofriend]

Good luck with your trainer mate.

[bluebird]

I'm working on my trainer for joint ops, using tsearch for the most part. I rather be using softice. Is there a way to load your programs (joint ops) into softice without having to make a sym file. or is there a quicker process than what I've been doing.

make a map file in IDA, then run through 2 conversions to get to a symbol file to load into softice. This info with softice in the past was very limited and this what I found to work, but would rather spend my time on my trainer than converting files.

Thanks in advance


anyone? :dead:

[Gregsy]

isnt softice a debugger?
therefore i think the softice hotkey is alt+d
is should debug the process from there,
but i havent used it yet so i dont know